Support and News Forum

Hi All,

Im having an issue of console/telnet not responding(stays blank).
I have disable all windows firewall and have allowed port 1-65000 bothways.
When i click on the device to console to it. The SecureCrt/Putty application launches.
However there is no response when i type i any command.
All i can see is as per attached screenshot.
I have tried most of the solution that came up in google.\
Any assistance on this is highly appreciated.

seems your issue is this point:

Q: Why Qemu nodes are slow on my I7 64G ram ?
A: Typically, Antivirus deep inspection slows down Vmware Workstation and Virtual machines. Last observation was that even nodes (vIOS, CSR) running on EVE were under AV inspection. Avoid using AV on Vmware binary.

You must check if your Antivirus is blocking run qemu nodes properly.. !!!!

I only have windows defender running.
Can you let me know how i can stop the defender deep inspection?

where is your eve installed?

It is a VM installed on VMware Workstation 15.

And what is that node? I assume it is qemu vIOS..
then another reason of such non booting it can be your antivirus which is check virtualization.
Q: Why Qemu nodes are slow on my I7 64G ram ?
A: Typically, Antivirus deep inspection slows down Vmware Workstation and Virtual machines. Last observation was that even nodes (vIOS, CSR) running on EVE were under AV inspection. Avoid using AV on Vmware binary.

You have to check if your AV virtualization check is disabled !!, after disable reboot pc is a must !
In Avast it looks like this:

Another reason, you simply had not prepared image right.... it show stsrated but actually it does not running, Here you have to recheck carefully our how to and how you prepared the image

Uldis