Support and News Forum

Hello, I have a problem with Nexus 9k images. Nexus boots with startup config from another lab.
For example I have fresh installed EVE-NG CE, I load Nexus image to the EVE. Create new lab add 3-5 Nexus switches, create some config and then save it to the startup. Then I close the lab or even delete it, create new lab and add Nexus switch, powered it on, and Nexus boots with startup config from difirent lab, config is the same always.

Image nxos.7.0.3.I7.5

you watch this how to:
https://www.eve-ng.net/documentation/ho ... figuations
node must be wiped before boot from exported cgf.

or worst case you have gotten image with saved some config.
btw this image is worst nxos.7.0.3.I7.5
use nxos.7.0.3.I7.6 better

Thank you for the answer.

I don't use exported cgf.

I've downloaded images from cisco.com

I will test nxos.7.0.3.I7.6