Page 1 of 1
Nexsu VXLAN over MPLS POC lab is not launching
Posted: Fri Aug 28, 2020 5:47 am
by irena2020
I am trying to load the Nexus VXLAN over MPLS POC lab written by UD.
Images used in a lab:
nxosv9k-7.0.3.i7.1,
viosl2-15.2
vios-15.6.
nxos and l2 are working fine, actually all images are working fine but I am unable to launch vios-15.6. Fixpermissions are applied, user error (typos) is checked, vCPU x20, RAM 80G. What else do I need to do to get vios-15.6 launch?
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Fri Aug 28, 2020 7:44 am
by Uldis (UD)
try find another image, or check if you made this image properly, names etc
foldername
vios-xxxxxx
inside must be virtioa.qcow2
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Fri Aug 28, 2020 3:16 pm
by irena2020
Thanks, Uldis. Will try again
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Mon Aug 31, 2020 3:43 pm
by irena2020
yes, so I tried a bunch of vIOS images. None worked in the VXLAN lab, however, when I create a new lab and run those images separately, all work just fine. So, I am thinking there might be some settings in the LAB which prevent the L3 vIOS images to run?
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Mon Aug 31, 2020 3:53 pm
by irena2020
It says " the node started" but nothing happened. The node is not accessible " connection refused"
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Mon Aug 31, 2020 7:13 pm
by Uldis (UD)
Before you start any lab need wipe nodes, right click wipe.
Then checj if proper image is assigned for the node.
Re: Nexsu VXLAN over MPLS POC lab is not launching
Posted: Mon Aug 31, 2020 8:43 pm
by irena2020
It worked! Thanks so much , Uldis!