Can't ping my default GW / physical Router in Bridge Mode via LAN?
Posted: Wed Dec 22, 2021 12:19 pm
Hi guys
I have a problem and need your help.
My installation looks like this:
EVE-NG Community current version
Host Windows10 Pro
VMware Workstation Pro 16
Now to my problem.
1st case:
If I use a WLAN card in bridge mode, I can reach all other VMs and also the Internet or my physical router from EVE-NG. I only get messages on the Cisco Node that duplicate IP was detected, although no duplicate IP is used. But it only works if I configure the IP addresses on Cisco Node statically. DHCP does NOT work. No idea why.
2nd case:
If I switch off WLAN and connect my computer to the router via LAN, then DHCP for Cisco Node works perfectly. The problem is, I can't reach my router. So my Cisco Node gets an IP address from my router, but I can't ping the router. I can't reach other VMs either.
Case 3: If I use NAT mode instead of Bridge, everything works fine.
I have a problem and need your help.
My installation looks like this:
EVE-NG Community current version
Host Windows10 Pro
VMware Workstation Pro 16
Now to my problem.
1st case:
If I use a WLAN card in bridge mode, I can reach all other VMs and also the Internet or my physical router from EVE-NG. I only get messages on the Cisco Node that duplicate IP was detected, although no duplicate IP is used. But it only works if I configure the IP addresses on Cisco Node statically. DHCP does NOT work. No idea why.
2nd case:
If I switch off WLAN and connect my computer to the router via LAN, then DHCP for Cisco Node works perfectly. The problem is, I can't reach my router. So my Cisco Node gets an IP address from my router, but I can't ping the router. I can't reach other VMs either.
Case 3: If I use NAT mode instead of Bridge, everything works fine.