Support and News Forum

Hey. I'm new to EVE-NG and have been using GNS3/VIRL for years. I think I have the process down of converting vmdk's, etc over to qcow2 formats. I see in the node list that the SonicWALL NSv virtual firewall is supported. My company I work for are gold partners with SonicWALL and I got the SonicWALL 200 VM. The file first came as an .OVA file, I extracted the .OVA to get the .VMDK file. I then did the normal operation of converting the .VMDK file to a qcow2 file and re-namining it virtioa.qcow2 and fixed the permissions. I still have the image grayed out once I try to add it to a lab. Any help is appreciated.

Thanks,

Chaz.

but foldername MUST be vcorrect dear.
As well your EVE CPU must have enabled Intel VT-X

What should be the folder name? The name of the appliance in EVE-NG?

Thanks for the link. So I have my folder name as sonicwall and the file is now renamed to sonicwall.qcow2. Is this correct?

no
folder must be sonicwall-xxxxx
but image filename is
hda.qcow2

Thank you! I have a SonicWALL now running in EVE. It's still booting up, so hopefully it works!

So the SonicWALL is partially booting up and then goes into a boot loop cycle. I have the NSv200 running 6.5 code. Is there a specific version EVE-NG supports?

it looks like this version is not supported as KVM image.
I tried convert it to qcow2 but same result as you told me, nooting by half, it starts but not going forward.
older version 11 worked fine
Uldis