Support and News Forum

I created a network topology and put basic IP addresses on it. Save the config and exported.
Turned off all nodes in topology and turned it on back and all configs booted as expected (not default with my basic IP addressing on it.)

Since I want to make this topology as my base (no routing protocols or whatsoever) , I just decided to clone it.

On the cloned setup , I can see that the startup config is there (with basic Ip addressing) , but somehow when I turned on the nodes , it is booting as default.

Anybody having the same issues?

On the cloned lab are the nodes setup with load exported config?

steps for correct clone labs:

source lab:
1. do configs
2. wr configs on all nodes
3. export configs

Cloninbg:
1. stop source lab which will be cloned
2. go to main tree where is lab and clone it
3. new cloned lab will appear

Cloned lab tuning
1. edit cloned lab and give new labname
2. open lab, check under configs if they persist
3. sidebar/more actions/set startup cofig to exported
4. wipe all nodes..


DONE you cloned lab will boot from exported cfg

UD

Thanks guys, working perfectly now