Cisco CSRv1000 16.x (Everest, Fuji, etc) shows no interfaces
Posted: Sun May 31, 2020 5:36 pm
Hi,
I have just successfully installed the image of a Cisco CSRv1000 16.x (16.09.05). The problem is, no Gigabitinterfaces are equipped in the node:
Router#sh inv
NAME: "Chassis", DESCR: "Cisco CSR1000V Chassis"
PID: CSR1000V , VID: V00 , SN: 9H83E5CJ1MU
NAME: "module R0", DESCR: "Cisco CSR1000V Route Processor"
PID: CSR1000V , VID: V00 , SN: JAB1303001C
NAME: "module F0", DESCR: "Cisco CSR1000V Embedded Services Processor"
PID: CSR1000V , VID: , SN:
It's like I have nothing but the chassis up and running. In the routers with IOS (Dynamips) we can add interfaces in the edit section. But for this router there is no option (or at least not in my case) to equip interfaces in the edit screen.
Any idea what I'm missing?
Thanks.
I have just successfully installed the image of a Cisco CSRv1000 16.x (16.09.05). The problem is, no Gigabitinterfaces are equipped in the node:
Router#sh inv
NAME: "Chassis", DESCR: "Cisco CSR1000V Chassis"
PID: CSR1000V , VID: V00 , SN: 9H83E5CJ1MU
NAME: "module R0", DESCR: "Cisco CSR1000V Route Processor"
PID: CSR1000V , VID: V00 , SN: JAB1303001C
NAME: "module F0", DESCR: "Cisco CSR1000V Embedded Services Processor"
PID: CSR1000V , VID: , SN:
It's like I have nothing but the chassis up and running. In the routers with IOS (Dynamips) we can add interfaces in the edit section. But for this router there is no option (or at least not in my case) to equip interfaces in the edit screen.
Any idea what I'm missing?
Thanks.