Eve-NG Question
Posted: Fri Feb 04, 2022 8:36 am
Hello everyone, found a post that says most who use eve-ng hangs out here. I'm trying to migrate from GNS3 to eve-ng
Been trying to make mine work for quite some time now, I've manage to get it up and running and even run a couple of Dynamips and IOLs (same ones I used on GNS3) and I encountered a couple of problems.
I could run Dynamips fine, I can open the terminal and config but for some reason when I connect the devices the arp table populates but I can't ping and reach the next device https://9apps.ooo/.
I can't run any of the IOUs, they don't start at all even when it says "node: XX started" it still looks offline.
Been scratching my head here but I can't seem to find any solution online.
I just wanted a reliable way to simulate L2/L3s and stuff from Fortinet and some ASAs
If anyone has a better solution other than GNS3 or eve-ng, would be appreciated.
Been trying to make mine work for quite some time now, I've manage to get it up and running and even run a couple of Dynamips and IOLs (same ones I used on GNS3) and I encountered a couple of problems.
I could run Dynamips fine, I can open the terminal and config but for some reason when I connect the devices the arp table populates but I can't ping and reach the next device https://9apps.ooo/.
I can't run any of the IOUs, they don't start at all even when it says "node: XX started" it still looks offline.
Been scratching my head here but I can't seem to find any solution online.
I just wanted a reliable way to simulate L2/L3s and stuff from Fortinet and some ASAs
If anyone has a better solution other than GNS3 or eve-ng, would be appreciated.