CCIE BGP Lab

[venerzky]

This lab is the same as Scott Morris lab with CBT Nuggets CCIE L3 Technologies.

Enjoy

Image: i86bi_linux-adventerprisek9-ms.155-2.T

[Uldis (UD)]

Good man
Happy to see how ppl creating nice labs

UD

[ali.daoud]

no configuration provided, is only topology is that correct ? thank you

[denqyj]

You can find the configuration of all devices in Startup-configs.

[yuzhaninaa]

Hi
There is a configuration for R25 only
Please post the topology again with configs
Thank you

[Uldis (UD)]

just imported this LAB.
All configs persist like it should. Thanks author for lab.

You guys do this:
1. unlock lab, on side bar is red button (unlock lab), click on it, to unlock lab
2. on side bar: More actions->set nodes set startup-cfg to exported
3. side bar: more actions wipe all nodes

DONE your lab is set boot from all saved cfgs..
You can start it

Ud

[yuzhaninaa]

all ok
trank

[tchuros]

This lab is the same as Scott Morris lab with CBT Nuggets CCIE L3 Technologies.

Enjoy

Image: i86bi_linux-adventerprisek9-ms.155-2.T

[votive]

Followed instructions by Uldis (UD) and everything is working well!

[votive]

just imported this LAB.
All configs persist like it should. Thanks author for lab.

You guys do this:
1. unlock lab, on side bar is red button (unlock lab), click on it, to unlock lab
2. on side bar: More actions->set nodes set startup-cfg to exported
3. side bar: more actions wipe all nodes

DONE your lab is set boot from all saved cfgs..
You can start it

Ud

Maybe I posted too soon. So, protocols are there but what is missing from the start-up is the IP addresses of the eth interfaces.

I so see them typed out in the STARTUP-CONFIGS section

Guess what am I doing incorrect please?


edit: Hmm, never seen this before

Code: Select all

R2(config)#interface Ethernet0/0
R2(config-if)#ip ad
R2(config-if)#ip ?         
Interface IP configuration subcommands:
  access-group        Specify access control for packets
  admission           Apply Network Admission Control
  arp                 Configure ARP features
  device              IP Device tracking
  dhcp                Configure DHCP parameters for this interface
  flow                NetFlow related commands
  header-compression  IPHC options
  igmp                IGMP interface commands
  rsvp                RSVP Interface Commands
  rtp                 RTP parameters
  verify              verify

R2(config-if)#ip