vSRX (firefly) 12.x - problems with loading configs

[mku]

Hi all,

I've tried today vSRX image, but looks like I have some issues with loading initial configs. Export seems to be working fine, as I see proper content in "startup files" dialog.
When I wipe all nodes and run them again I see following messages on the console:

Code: Select all

Verified junos-vsrx-12.1X46-D10.2-domestic signed by PackageProduction_12_1_0
Loading configuration ...



mgd: error: Cannot open configuration file: /config/juniper.conf
mgd: warning: activating factory configuration

and my config doesn't load.

Any idea why is this happening?
Thanks!

[mike]

Did you watch video or something how to properly do it?
Did you enable/checked that it is setup to boot from exported config?
If all good, did you wait enough to see what happens when image boots?

[mku]

Hi Mike,

Thanks for your reply.
I'm already using CSR1kv, XRv and vMX, so it isn't that new to me. I've followed instructions in "how to" section of EVE-NG main page and the image boots fine.
There aren't any extra steps comparing to other images.

Yes, the node is set up to boot using exported configs.
Yes, I closely watched console and posted outputs in my first post.
I think that node is looking for startup configs (juniper.conf) but isn't able to load them. So it falls back to factory defaults.

[mike]

what is the image name? in the folder I mean? hda?

[mku]

It's virtioa.qcow2, as per "how to".

[Chris929]

Hi,

I have no provlems - neither with vSRX(Firefly 12.x) nor with the vSRX-NG (15.X, 17.X).
Config Export, wipe and "config-import" work fine.
Have you tried to re-setup your lab? maybe your node is broken.

Regards
Chris