XRv console blank

[prime]

Hi,

I've EVE running in a VM Workstation and I'm facing an issue that when I start XRv boxes, they show up as blue, but when I open the console it's blank. I've reinstalled EVE twice now, made sure Intel Vt-d is enabled in BIOS. My 7200 dynamips image is working fine though. I've tried copying some other qcow2 images also from a different installation, which is also not working. I also have old version of UNL in VM, which also have problem with XRv now. Couple of months back, when I last used these (both UNL and EVE) XRv was working fine. After stopping XRv in web page, I'm getting some logs like this.

eve.png

Any idea what to do?

[Uldis (UD)]

Only answer is: improperly prepared XRv image

this one is how to prep image from VMDK
http://www.eve-ng.net/index.php/documen ... -from-virl

this one for XRv node from ova:
http://www.eve-ng.net/index.php/documen ... -cisco-xrv

UD

[prime]

Thanks for your reply.

I had working UNL as well as EVE couple of months back. XR (5.2.2 and 6.x) was also working fine in that. I just tried opening it again recently for practice that's when it started this behavior. So I'm pretty sure XRv images were prepared properly. Anyway I reinstalled EVE twice now, XRv was prepared from the OVA using the same link that you pasted, but console is blank.

[Uldis (UD)]

It can be Antivirus issue as well, if is turned on virtualization check on it.
AVG for example..
Go to menu>settings>troubleshooting, then, under "enable hardware-assisted vertualization" uncheck "use nested virtualization where available". That allows a VM to use its own virtualization.

Ud

[prime]

That was it! Thanks a lot.

I had installed Avast a few months back, when I was not using EVE, so that's why it stopped working. Changed that setting and after reboot it's working again. Thanks again